Max. Range mm	1500
Min. Range mm	150
Beam angle(°)	10
Carrier frequency	220 kHz
Temperature compensat.	Yes
Interface	RS485
Sensitivity adjustment	Potentiometer
Analogue output	0-10V
Repeatability	2 mm; 0.4%
Response time (ms)	100
Linearity	0.5% / 3mm
Output adjustment	Prog.
Switching output	Prog. 5-30 Hz
Output circuit	Open collector 100 mA
Set point adjustment	Prog.
Information output	Serial HEX/BCD
Alignment LED	Yes
Control inputs	Hold/Synchronisation
Temperature range	-15-+70 °C
Storage temperature range	-25-+85 °C
Supply voltage	19-30 V DC
Current consumption without load	<=25 mA
Reverse polarity	Yes
Voltage spikes on supply and output lines	Yes
Short circuited switching output	Yes
Sealing IP	65
Housing	Stainless steel

If a measurement is only to take place in a certain instant, the sensor transmit and receive can be suppressed by a LOW (0V) at the hold HLD input. The last calculated distance is stored and output. During programming the HLD input should also be connected with the HLD line. If the sensor is enabled once more (HLD open or HIGH), a new output occurs after completion of a measurement cycle. To avoid mutual interference from several sensors, these are very simply synchronised by interconnecting the hold inputs. Programming with UDSPROG software. Additional adjustments: sensor address, blind zone, cycle time, digital filtering, mean value, measuring window, over range counter.

• Delivery of spare parts and industrial equipment throughout the USA by Fedex transport company.
• Flexible payment system accepting bank transfers, MasterCard, VISA, PayPall, App Pay, Google Pay.
• Directly from stock and on order.